Shimano Sienna 2500 FD
Last Post 21 Jun 2011 08:56 AM by Barresi. 9 Replies.
Author Messages
Dennis1022User is Offline Advanced Poster Advanced Poster Send Private Message Posts:216 Dennis1022
--
27 Aug 2010 06:31 AM
    We all have this reel if your a life member. Well I just started to have this problem with the drag. I have set the drag to have the fish little play but not to run all the spool out. So I tightened the drag more and the drag still let the line pull out very easy. So any idea's why the drag is do this, and how to fix the problem.
    Dennis
    Always Practice Everyday> Catch, Weigh, Measure, Photograph and Release !! Dennis
    slipperybobUser is Offline Veteran Poster Veteran Poster Send Private Message Posts:1240 slipperybob
    --
    27 Aug 2010 06:37 AM
    Not me, because when I was a life member the club offerred no such thing...

    One question:  Do you loosen the drag between (delayed) outings?
    PegsguyUser is Offline Veteran Poster Veteran Poster Send Private Message Posts:4095 Pegsguy
    --
    27 Aug 2010 08:58 AM
    I have about a dozen Shimano spinning reels in the same price category as the Sienna and they all use a common spool. I have yet to experience a problem like this. The only time I had something even close happen, it turned out the line was wound too loosly(my fault) and was tightening up. I would suggest taking the drag apart and checking for contaminants. The drag washers are in the spool and can be removed after carefully removing the spring wire retainer. Pay attention to the order that the parts come out in! If all else fails, new spools are available. Tom
    Lifer in NE Illinois Gen. 1:28 I didn't rise to the top of the food chain to become a vegitarian!
    basbanditUser is Offline Advanced Poster Advanced Poster Send Private Message Posts:547 basbandit
    --
    27 Aug 2010 10:49 AM
    I have two Shimano Stradic reels that I have had for over fise years, and have never had any drag problems at all with them. I can tell you this, any time the teh reel is not in use the drag should be backed off to were there is no resistance at all on the system. This applies to spinning and baitcasters. If left tightened the drag washers will eventually set a memory in the tightened position, and no mater how tight you make it the drag will still let the line out. I learned this the hard way. ruined a couple by not loosening the drag.

    Harry
    Trophy Life Member USN Retired 1969-1989 NW Bass Pro Washington State
    slipperybobUser is Offline Veteran Poster Veteran Poster Send Private Message Posts:1240 slipperybob
    --
    27 Aug 2010 02:17 PM
    Oiled felt drags may just need some fresh oil to give it some more life. I wouldn't hesitate to use some of Shimano Drag Star Grease.
    jaysun7776User is Offline New Poster New Poster Send Private Message Posts:185 jaysun7776
    --
    11 Jun 2011 12:57 AM
    Basbandit I didnt realize that about the drag washers thanks for the tip sir !!
    jaysun7776User is Offline New Poster New Poster Send Private Message Posts:185 jaysun7776
    --
    19 Jun 2011 12:21 PM
    The drag washers can be replaced though right if this happens ??
    AZAllenUser is Offline Veteran Poster Veteran Poster Send Private Message Posts:2427 AZAllen
    --
    20 Jun 2011 10:30 AM
    Mine says Samuri 2500 and drag washers should be replacable as long as someone still has parts.
    NAFC, NAHC, NRA, SASS, Viet Nam Vet. Bullhead City, AZ
    PegsguyUser is Offline Veteran Poster Veteran Poster Send Private Message Posts:4095 Pegsguy
    --
    20 Jun 2011 01:16 PM
    Is it really worth putting $20 worth of parts into a $30 reel? A replacement spool might be available from a source other than Shimano (last time I bought a Shimano spool it was about $20)
    Lifer in NE Illinois Gen. 1:28 I didn't rise to the top of the food chain to become a vegitarian!
    BarresiUser is Offline Advanced Poster Advanced Poster Send Private Message Posts:630 Barresi
    --
    21 Jun 2011 08:56 AM
    It's probably your drag discs/washers need to be replaced or cleaned. Most problems occur with the drag when anglers dont properly set the drag. You should always have some play in your line...When your drag is over tightened...over time it will "freeze" up and will be useless...I would open it and inspected the drag discs...clean or replace if needed...on that Shimano reel, it should only be a few dollars for new discs...Remenber to clean your reel after each use...with fresh water, not lake water and definatley not saltwater...and when you put your reel away for the day, loosen the drag so it doesn't form a memory, like basbandit said. After each season has ended..I breakdown all my reels and and clean them, then oil and lube so there ready to go next spring...


    ---