Forums > Fishing Club Forum > Fishing Boats, Motors & Other Equipment
Minn Kota shaft
Last Post 22 May 2012 09:38 AM by Pegsguy. 2 Replies.
Printer Friendly
  •  
  •  
  •  
  •  
  •  
Sort:
PrevPrev NextNext
You are not authorized to post a reply.
Author Messages
BadgerUser is Offline Advanced Poster Advanced Poster Send Private Message Posts:274 Badger
--
21 May 2012 08:05 PM
    What do you guys use on your bow mount motor shaft when it gets hard to slide from the cradle. Mine is a bear at times when it's dry. I've been told wd40 helps but that is just short term. Any suggestions?
    Hayward Lakes Wi ----- Life member since 1994
    BarresiUser is Offline Advanced Poster Advanced Poster Send Private Message Posts:630 Barresi
    --
    22 May 2012 01:53 AM
    Try White Lithium Grease, made by CRC. It's a marine grade grease designed for saltwater use. Lasts long and it won't break down. Comes in a spray can.
    PegsguyUser is Offline Veteran Poster Veteran Poster Send Private Message Posts:4095 Pegsguy
    --
    22 May 2012 09:38 AM
    That is a good idea, you might also try one of the synthetic, waterproof marine lubes on the market. A little goes a long way, too much and you attract dirt and grit.
    Lifer in NE Illinois Gen. 1:28 I didn't rise to the top of the food chain to become a vegitarian!
    You are not authorized to post a reply.

    Forums > Fishing Club Forum > Fishing Boats, Motors & Other Equipment